FLUSH MOUNT SOFT HATCH TONNEAU COVER

Top to Topless in 20 Seconds

Click Here To Select Products 

The Ultra-Low Profile Soft Hatch Lift Cover from Craftec rises above its competitors.  A true Soft Hatch Truck Bed Cover that improves your gas mileage and protects your cargo.

• The cover can be easily removed in two ways:   simply lift hatch, remove gas shocks and raise hatch to vertical position, then pull back to release and remove.   Or simply peel the vinyl off the framework.
• There is no drilling to install most models (A small amount of drilling is required on special models such as the Chevy Sportside, Ford Flareside & Splash).
• No Snaps, Velcro or J-Hooks to deal with.   A strip of polypropylene plastic is sewn into the cover and this wraps around the framework, held into place by part of the aluminum framework.
• Will not work with over the rail bed liners but can be used with under the bed rail liners if front of bed liner is trimmed so the front hinge can be directly attached to the front of the bed.
• The cover is very low profile.   It sits on the lip of the bed about 3/8”in height.   Retains the original lines of your truck.
• Framework used is heaviest gage heat treated aluminum in the industry.
• Comes complete with gas struts and all hardware for assembly.
• Bed rails can be used if there is 1 1/4" clearance measured from the inside of the box to the edge of the base.
• Bows are included:   two in most applications, three in the long bed models.   The bows have an arch of 1” to 1 1/2"thus retaining the low profile look and avoids standing water problems.
• Hidden rear latches, cannot be seen with tailgate closed.
• Clean with common household soap, do not use vinyl cleaners.
• UPS Shippable

Click Here To Select Products 

			Click HERE to see additional photos

sales@craftecinc.com

Technical Support 1- 800 Craftec
Phone orders 1- 800 272- 3832
Craftec Inc. 23710 STATE ROAD 213 N, NOBLESVILLE, IN 46060