TOOL BOX-CUSTOM FIT FOR YOUR TRUCK BED & TOOL BOX

Easy Removal from Truck in about 20 seconds

Click Here Select Products 

• Only two measurements needed to build the cover.
  
• At least 1" of clearance is needed from the top of the bed rail to the bottom of any handles or latches on the front of the toolbox.
  
• Allows Full Access to Truck Bed
  
• Clamps On:   No drilling to install on most trucks.
  
• No marring of your truck paint finish.
  
• No Velcro or Snaps.
  
• Velcro wears out/snaps rust or tear through the vinyl.
  
• Cover is designed to be a Lift Up-Hatch style with a heavy duty
  
• Aluminum framework. A strong frame makes for a long lasting quality product.
  
• Highest quality gas struts included with every cover, so you have effortless opening and closing of your bed cover.
  
• Easy vinyl removal—Peel off from the frame.
  
• Makes for full truck bed use if needed in an emergency away from home.
  
• Square tube bows. Strong yet light weight, keeps cover tight.
  
• 3/4” Square aluminum corner brackets. Ultra strong for frame stability.
  
• Unique interlocking “C” hinge. Makes installation & removal fast and easy.
  
• Very low profile-Sits about 3/8” above truck bed. Enhances the appearance of your truck.
  
• Heavy weight, high quality tonneau vinyl. Made specifically for tonneau cover use, UV resistant.
  
• Double edge binding used on the edges of the cover. Makes for a finished look for your truck.
  
• Co-extruded plastic weather seal. Eliminates any adhesive seal problems.
  
• Works with most under the rail bed liners. Designed to clamp on to the inside bed rails.
  
• A small amount of drilling is required on special models such as the Chevy Sportside, Ford Flareside & Splash.
  
• Over the rail bed liners will need to be slightly modified.  Two areas on each side would need to be slightly trimmed so the hardware clamps will attach to the rail of the truck bed.  This trimming will allow the cover to work with over the rail bed liners without removing the liner.
  
• Cover lifts up for cleaning. Dirt accumulation under clamp on covers can wear paint off and cause rust.
  
• No left & right hand parts, make for easier assembly.
  
• All major parts are numbered to correspond with numbers in the directions and drawings. Easier assembly (Link to assembly instructions)
  
• Framework is adjustable. Keeps cover tight in all weather conditions and temperatures.
  
• Handy pull down strap, makes closing cover easy.
  
• A quality weather seal is attached to the cover, it will sit on the edge of the truck bed ¾” from the inside of the box.
  
• The seal is attached to the cover and not to the bed which makes it very weather resistant.
  
• Limited lifetime on the frame and 2 years on the vinyl.
  
• Hidden rear latches cannot be seen with tailgate closed. Better security for your cargo.